Victron Energy Inverter MultiPlus 24/5000/120-100 230V VE

The system combines a pure sine wave inverter with a sophisticated battery charger with adaptive charging technology. Also compatible with lithium batteries. Two AC outputs. In the event of a power failure from the shore or generator, the device takes over in inverter mode to power whatever is connected, without interruption. The second output is only available in the presence of an AC source. Devices that could drain the battery, such as boilers, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect three units of the same type for three-phase current. Up to 6 sets of three units can be connected in parallel. Power control: the MultiPlus is very powerful and can absorb a lot of power from the shore or generator. With the MultiControl panel (14.270.32) you can monitor the power consumption by setting a maximum limit. The MultiPlus, taking into account the set limit, will only use the remaining energy to charge the batteries. Power assist: When a short-term power peak is required, the MultiPlus will compensate for the insufficient power by drawing energy from the battery. When the load reduces, the excess power is used to recharge the batteries. The microprocessor-controlled charger has a 4-stage bulk-absorption-floot-storage charging system similar to the Phoenix/Skylla battery charger. - Aluminum housing - Protection against short circuit, overload, low or high battery voltage, high ripple frequency, etc.