Victron Energy Multiplus System 800 W

VICTRON MULTIPLUS Combo System - Battery Charger + Inverter § The system combines a pure sine wave inverter with a sophisticated battery charger with adaptive charging technology. Also compatible with lithium batteries. Two AC outputs. In the event of a power failure from the shore or generator, the device takes over in inverter mode to power whatever is connected, without interruption. The second output is only available in the presence of an AC source. Devices that could drain the battery, such as boilers, should be connected to this output. Parallel + three-phase function. Up to 6 devices can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 series of 3 units can be connected in parallel. Power control: the MultiPlus is very powerful and can absorb a lot of power from the shore or generator. With the MultiControl panel (14.270.32) you can keep the power absorbed under control by setting a maximum limit. The MultiPlus, taking into account the set limit, will only use the remaining energy to charge the batteries. Power assist: if a power peak is required for a short time, the MultiPlus will compensate for the insufficient power by drawing energy from the battery. When the load reduces, the excess power is used to recharge the batteries. The microprocessor-controlled battery charger has a 4-stage bulk-absorption-floot-storage charging system similar to the Phoenix/Skylla battery charger. - Aluminum casing - Protection against short circuit, overload, battery too low or too high, high ripple frequency, etc. § Type, C12/800/35, Power supply V-DC, 9.5 - 17, Inverter power W, 800, Output V, 230VDC ± 2%, Battery charging current A, 35+4, No. of outputs, 1+1*, mm, 360x240x100, 6.4